reveible plug gages

the reveible plug gage has the advantage that it can be reveed and used at the opposite end when one end becomes worn and goes out of tolerance. the gaging membe are simple pi that can be removed from the handle by loosening the collet nuts at the ends. each end of the handle is color coded, green for go and red for nogo. depth steps are available upon request. available in steel, carbide and chrome. extra long membe available. gaging surfaces are hardened to rc 58-62. taperlock plug gages:

the taperlock gage is named because of the tapered shank, which locks into the tapered hole in the end of the handle. used for gages up to 1 â½ inches. as a further aid in identification, the go and nogo membe have a different length of gaging surface. it is permissible to make the nogo gage shorter because it is not supposed to enter the part. depth stops are available upon request. available in steel, carbide and chrome. gaging surfaces are hardened to rc 58-62. trilock plug gages:

the trilock design has been found best suited for gages between 1 â½and 8 inches in diameter. the trilock feature is the source for the name of this design. the handle has three prongs on the ends, which fit into three grooves equally spaced around the central hole of the gage membe. a bolt holds the member to the handle and the trilock grooves and prongs stabilize the member. like the pin (reveible) type, trilocks are reveible, since either face can be locked to the handle. available in steel, carbide and chrome. gaging surfaces are hardened to rc 58-62. progressive plug gages:

in some special cases, a little gaging time can be saved by putting the go and nogo diamete on a single gage member. a progressive plug, for example, is suitable for checking a short hole, which is open at both ends. obviously, the hole cannot be deeper than the go section of the plug. master setting discs:

style 1 style 2 style 3 master setting discs are used for setting comparato, snap gages and other precision gages. they are furnished with iulated grips to prevent heat distortion. also available are holde for bench top working. discs above 2.510//63.75mm are black oxide on all non gaging surfaces. discs above 2.510//63.75mm are trilock design. available in steel, carbide and chrome.